N'ozuzu, wiring harness loop detection platform ka a na-eji achọpụta ihe na-ezighị ezi na nke mepere emepe. ngwaọrụ nchekwa. Na sekit nke usoro ike, ebe a na-agbanye ígwè, ọ ga-ere ọkụ ebe ọ dị. Na nkwụsị nke ọkụ na ebe a na-adịghị emebi emebi, eriri waya na ebe a bụ ala; Ọ bụrụ na a na-ere eriri ọnụ ọnụ na akụkụ wiring nke ụfọdụ ngwa eletriki Ọ bụrụ otú ahụ, ọ pụtara na ngwa eletrik adịghị arụ ọrụ. nke mere na oyi akwa mkpuchi waya n'ime mebiri emebi, na-eme ka obere sekit dị n'etiti wires, na fuse na-afụ. Ọtụtụ n'ime mmejọ na-eme na njikọ, nke na-eme ka ngwa eletrik ghara ịrụ ọrụ nke ọma. Mgbe ị na-ekpe ikpe, gbanye ike nke akụrụngwa eletrik, dọpụta ma ọ bụ metụ njikọ dị mkpa nke ngwa eletriki ahụ aka. Mgbe emetụ ụfọdụ njikọ aka, ngwa eletrik nwere ike ịrụ ọrụ na mberede, na mberede ọ nweghị ike ịrụ ọrụ. Ọ pụtara na njikọ ahụ anaghị arụ ọrụ nke ọma.

　　1. The terminal wiring harness is burned out, and the burning speed is relatively fast, generally there is no safety device. In the circuit of the power system, where the iron is grounded, it will burn where it is. At the junction of the burned out and the intact place, the wire grounding in this place is the ground; if the terminal harness is burned to the wiring part of a certain electrical equipment If so, it means that the electrical equipment is malfunctioning.

　　2. The terminal wiring harness was squeezed and impacted from the outside, so that the wire insulation layer inside was damaged, causing a short circuit between the wires, and the fuse was blown. Most of the faults occur in the connector, which makes the electrical equipment not work properly. When judging, turn on the power of the electrical equipment, pull or touch the relevant connector of the electrical equipment. When a certain connector is touched, the electrical equipment suddenly can work, and suddenly it can’t work. It means that the connector is malfunctioning.