1.Mold mmebi

　　N'ihi arụrụ arụ ọrụ na-adịghị mma (crimping nke abụọ, wdg) na ebufe ebu, ihe dị elu na nke dị ala na-afụ ụfụ ma ọ bụ gbajie. Ya mere, enweghị ike ịpụpụ ọdịdị ahụ mgbe niile ga-akpata nnukwu nsogbu dị ka burrs. Enwere ike ịchọta ihe na-adịghị mma site n'ịleba akụkụ ahụ na-emebi emebi.

　　Nrụpụta njedebe

　　Oghere a na-ekwe ka ọ dị iche dabere na ọnụ, yana n'ozuzu ya nọ n'ime ± 5°. Ọnụ ọnụ gbagọrọ agbagọ ga-emepụta otu ntụpọ dị ka agbagọ n'akụkụ.

　　2.Terminal deformation

　　Bend up:

　　Oghere a na-anabata na-adịgasị iche dabere na njedebe dị iche iche, n'ozuzu n'ime 3 Celsius. Enweghị ike ịtinye ọdụ ọdụ agbagoro elu n'ime shei ahụ. Ọbụlagodi na enwere ike itinye ha, ha ga-apụ na ntu wee mee ka ọ dabara adaba n'akụkụ nke ọzọ. Enweghị ike ịtinye ọdụ ụgbọ ala gbadara ala n'ime shea ahụ, ọ bụrụgodị na enwere ike ịtinye shea ahụ, ntu ahụ ga-apụ, ọ ga-eme ka ọ ghara ịdị mma na nsọtụ nke ọzọ.

　　Bend down：

　　The allowable angle varies somewhat depending on the terminal, and is generally within 3°. Terminals that are bent downward cannot be inserted into the shell, and even if the shell can be inserted, the nail will come off, and it will cause poor fitting at the other end.